The CPX is an affordable line of amplifiers geared toward the
MI and DJ markets. A tradition of great sound quality, flexibility
and reliability is carried over into the Crest Performance
series. Industry standard connectors and features make the
CPX a great backbone for mobile sound systems, project studios
and many other applications. Musicians will also find
CPX as the power amp of choice.
Power points: Crest CPX amps are available in three models,
CPX900, CPX1500 and CPX2600. Power capabilities range
from 180 Watts to 2200 Watts. CPX amps will drive loads that
range from 8 Ohms stereo to 2 Ohms stereo, or 4 Ohms
bridged.
Feature set: With a comprehensive set of features including
built-in signal limiting, low pass filters and low frequency
crossovers with direct outputs, the CPX line addresses several
applications and serves as a low-cost solution for most
power amplification needs.
Features
- GCL Gain Comparator Limiting system with rear panel defeat switch
- Built-in Crossover
150 Hz, -24 dB per octave Linkwitz-Riley filter, tuned for subs
Individual in/out switches for Channels A and B
1/4 daisy chain outputs
- Built-in low cut filter
-18 dB per octave at 80 Hz
Individual in/out switches for Channels A and B
- Input connectors – Barrier strip, Female XLR 1/4 TRS
Pin 2 hot
- Outputs connectors
SpeakonsTM for Ch A and B and Bridged mono
Binding posts for Bridge mode
- Mode selector switch for stereo and bridged-mono operation
- Two speed DC Fan
Protection Circuitry
GCL (Gain Comparator Limiting): Monitors input/output gain and
reduces signal when distortion or excessive high current conditions
occur. Protects loudspeakers from dangerous transients and unexpected
level changes.Transparent in operation, yet very effective for
its designed purpose.Thermal: Amp monitors internal heat sink temperature and temporarily
shuts down during extreme thermal conditions.DC Triac Crowbar: Prevents amplifier from putting out or receiving
dangerous DC over the speaker lines.Turn On/Off Muting: Outputs are muted during turn on and turn off
to prevent audible pop through speakers.Specifications
- Stereo power 8 ohms 1kHz, 0.1% THD+N: 500W
- Stereo power 4 ohms 1kHz, 0.1% THD+N: 750W
- Stereo power 2 ohms 1kHz, 1% THD+N: 1100W
- Bridged mono power 8 ohms 1kHz, 0.1% THD+N: 1550W
- Bridged mono power 4 ohms 1kHz, 1% THD+N: 2200W
- Hum & Noise Stereo mode, Below rated output power, 4 ohms: 100 dB
- Input sensitivity & Impedance @ rated output power, 4 ohms:
- 1.5 V RMS (+3.5 dBv)
- unbalanced, 1/4″ phone jack: 20K Ohms
- balanced, XLR: 10K Ohms
- Overall system gain per channel: 40X (+32dB)
- Distortion SMPTE-IM: less than 0.01%
- Stereo mode, both channels driven, 4 ohms 20 Hz to 20 KHz, 10dB below rated power: less than 0.03%
- 20Hz to 2 KHz, at full rated power: less than 0.03%
- Frequency response Stereo mode, both channels driven +0, -1dB @ 1W RMS, 4 ohms: 20Hz to 20kHz
- +0,-3dB @ rated output, 4 ohms:5Hz to 50kHz
- Damping factor (typical value)
- Stereo mode, both channels driven 8 ohms, 1 kHz: >300
- Power consumption Stereo mode, both channels driven @ 1/3 output power, 4 ohms 120 VAC: 10.0A
- Topology Class H
- Weight 49 lbs. (22.3 kg)
- Dimensions 3.5″H x 19″W x 14″D
- 8.9 cm H x 48.3 cm W x 35.6 cm D